10 common problems and solutions of DC brushless barrier gate

Below, Baikong Intelligence summarizes several common issues that customers encounter when using DC brushless barrier gates:

Problem 1: The lifting rod is not vertical and the lowering rod is not horizontal

Solution: Loosen the fixed motor shaft screw while the pole is in the raised state and push the pole straight; Fixed screws.

Question 2: The pole landing motor is still running

Solution: The chassis is crooked; The ground is uneven; Release the position of the spindle adjustment rod clamp

Question 3: Power off of the controller when the barrier gate is raised and lowered in place

Solution: Insufficient power supply voltage; Motherboard damaged

Problem 4: Remote control malfunction; Remote control distance is close

Solution: The remote control battery is low; There is signal interference or receiver damage between the remote control and receiver

Question 5: The barrier gate shakes when it rises and falls in place

Solution: Check if the spring tension is balanced or if the motherboard increases the deceleration angle

Problem 6: The motor is running but the pole is unresponsive

Solution: The connection between the motor and the gearbox is damaged or the spindle screw is loose

Question 7: The barrier gate rod falls halfway and stops running

Solution: Check the spring ratio and rod drop speed

Question 8: The radar keeps detecting the pole

Solution: Tilt the radar or adjust the installation position

Question 9: The ground sensing coil keeps triggering

Solution: Vehicle inspection device malfunction or coil damage; There are a large amount of metals in the area; Wiring issues.

Question 10: The pole falls into place; The motor has been running slowly and repeatedly over short distances

Solution: Insufficient motor travel; The lock is not in place; Increase the motor stroke.